The correct operation method is the guarantee of the work of the mechanical equipment. When we use the equipment, we often use the equipment to speed up, or take a chance, and violate the operation requirements of the Lumberjack Log Splitter, thus causing indelible pain. Although Lumberjack Log Splitter is a device, it has a lifespan. If the operation is not standardized, or if it is used for a long time, it will cause Lumberjack Log Splitter to malfunction. Therefore, the key that users need to master when using Lumberjack Log Splitter correctly.
First, correctly operate the Lumberjack Log Splitter process. Before using and operating Lumberjack Log Splitter, do a comprehensive inspection of the technical conditions of all parts of the equipment, and there is no abnormality in the normal boot operation. When starting to work, realize the idling of the equipment for 1-2 minutes, check that there is no abnormality in the operation, and start the normal feeding and processing operation. When adding materials, it must be carried out at a uniform speed. Do not carry out more and more times. This will affect the discharge and the wear of the blades in the crushing chamber is different, so that after a long time, the equipment dynamic balance will fail .
Second, the size of the material. Different models of Gasoline Log Splitter allow different maximum materials to be added. Therefore, during processing and production, you must know the maximum diameter of the gasoline Log Splitter inlet. For the moisture content of the raw materials, Tongying Machinery Gasoline Log Splitter does not require much, as long as the raw materials are not soaked in water for a long time.
Third, ensure safe production. A protective fence should be installed at the transmission. The operator should stand on the feeding side, never stand at both ends of the Gasoline Log Splitter. The cuffs of the clothes should be tied up, and the long hair should be wrapped in the work cap. Before the materials enter the hopper, remove iron nails, stones and other debris to avoid damage to the machine. During the feeding process, if the feeding port is blocked, do not clean it by hand and stop the machine to clean the blockage. If you use motor power, you should cut off the power before troubleshooting. Fireworks are prohibited at the work site, and it is forbidden to increase the output by increasing the speed.
Fourth, maintenance cannot be ignored. When the Gasoline Log Splitter is working, the bearing temperature cannot exceed 40 degrees. If the bearing temperature continues to rise under normal working conditions, it should be shut down immediately for inspection to find out the cause and troubleshoot.
