During the use of Black Diamond Log Splitter, there will be many failures due to this and other reasons. Therefore, all aspects of protection testing should be done before starting Black Diamond Log Splitter. This can reduce the occurrence of a lot of troubles and reduce the Black Diamond. Damage rate of Log Splitter. Many users reported that their Black Diamond Log Splitter would have a relatively large vibration before being forced to shut down, and it would be damaged after abnormal operation for a while. So how does the Black Diamond Log Splitter do a good job of detecting vibration signals?
1. When the blades of the Black Diamond Log Splitter are entangled by impurities in the water and the impeller of the pump is out of balance, it will cause severe vibration of the pump. The piezoelectric vibration sensor is connected to the pump to detect the vibration of the submersible sewage pump in time. So as to know whether the sewage pump is operating normally. The sensor is composed of a spring, a mass piezoelectric piece and a base. The sensor base is rigidly fixed near the bearing between the submersible pump motor and the pump to sense the mechanical vibration of the pump.
2. When the sensor is subjected to vibration, since the stiffness of the spring is quite large and the mass of the mass is relatively small, it can be considered that the inertia of the mass is very small. Therefore, the mass feels the same vibration as the sensor base and is subjected to the direction of acceleration. The action of the opposite inertial force, in this way, the mass has an alternating force proportional to the acceleration acting on the piezoelectric element. Because the piezoelectric element has a piezoelectric effect, it generates alternating charges on its two surfaces.
3. In order to detect the Rapid Splitter information in real time, temperature sensors, vibration sensors, oil and water probes for water leakage detection, and float switches are selected, and the pump and motor are monitored and protected through the control circuit. It is also hoped that the majority of users will realize that during the operation of the submersible sewage pump, the detection signal of the working condition is an information carrier that reflects the normal or abnormal operation of the pump, and an appropriate detection method is an important condition for finding fault information.
