Gasoline Log Splitter bearing maintenance:
If the wood flour machine bearings are overheated, it will affect production or safety hazards. Therefore, maintenance should be performed to avoid overheating.
First of all, the two bearing seats of the mobile wood flour machine are uneven, or the motor rotor and the crusher rotor are not concentric, which will cause the bearing to be affected by the additional load, which will cause the bearing to overheat. In this case, please stop using the mobile wood flour machine and troubleshoot immediately to avoid early damage to the bearing.
Secondly, if the fit between the bearing cap and the shaft is too tight, and the fit between the bearing and the shaft is too tight or too loose, the bearing will overheat. Once such problems occur, friction noise and obvious vibrations will be generated when the equipment is running. Stop using the mobile wood flour machine and remove the bearings. Trim the friction parts and reassemble as needed. Too much lubricating oil in the bearing, too little or aging is also the main cause of damage to the bearing due to overheating. Therefore, it is necessary to add lubricant in a timely manner according to the requirements of the instruction manual. Usually, lubrication accounts for 70%-80% of the bearing space. Too much or too little is not conducive to bearing lubrication and heat transfer.
Replace the screen of the wood flour machine:
The screen plays a role in screening and filtering materials during the whole work process, and at the same time ensures the size of the hammer crushing gap. It is also part of a small wood crusher that is prone to severe wear. The customer needs to modify the parts after a period of use. Replace to ensure high-volume operation of the equipment. When replacing the parts of each part, as long as you understand these steps, you can handle it quickly and correctly. Some details usually indicate the skill level of the operator.
In the actual use of the small wood flour machine of Log Splitter manufacturers, the wear rate of the screen is high, and the replacement rate of other parts is also high. The replacement process of the screen of the small wood flour machine is very simple, and the whole process only takes a few minutes to complete.